Salty's Forum

General Category => Plug / Lure Building Forum => Topic started by: dpalinsk on August 05, 2016, 02:39:09 PM

Title: Question - securing GT 5.5 and 3oz Blabber Mouth to lure turner
Post by: Out Fishing on August 05, 2016, 02:39:09 PM

I bought a few each of the 5.5 GT Popper and 3oz Blabber Mouth kits.  These are the first thru-wire kits I have bought or made.  I'm going to seal the lures with a coat of epoxy, paint and then top coat with epoxy.  I have a lure turner and I'm trying to figure out the best way to secure these poppers to the turner for the seal coat of epoxy since thru-wire will not be installed until after painting.  All assistance is appreciated.

Thanks,

David

Title: Re: Question - securing GT 5.5 and 3oz Blabber Mouth to lure turner
Post by: Out Fishing on August 05, 2016, 03:38:39 PM

large cup hooks can be found at HDepot which can fit in the ends.