Print Page - danny thru wire

Title: danny thru wire
Post by: brookeny on November 15, 2010, 05:18:19 PM

Why is it bend at the fron t end? how do i piut it thru? do i straighten it out?

Title: Re: danny thru wire
Post by: Salty on November 15, 2010, 05:21:27 PM

Yes unbend it. It's done like that to fit in the packaging.

Title: Re: danny thru wire
Post by: Salty on November 15, 2010, 05:22:42 PM

Straighten by hand. Do not take the loop out of the end.

Title: Re: danny thru wire
Post by: brookeny on November 15, 2010, 05:24:55 PM

thanks so much!! love the kits

Title: Re: danny thru wire
Post by: Salty on November 15, 2010, 05:27:01 PM

Your welcome. Pictorials are here: http://www.saltys.co/kitinstructionspage.htm (http://www.saltys.co/kitinstructionspage.htm)

Salty's Forum