I agree, good job. Box, bulbs and hangers. Thanks for posting your Pics.
nj those motors look familiar, are they off of a grill rotisserie? If not please advise.
Assuming they are grill motors, did you use the 5/16 square rods? I saw on line that you can get 5/16 . round stops with set screws that could possibly be used for bearings ??
Saw a gal fly tier using same for turning epoxy heads. Pulled mine off today ...
Bought 5 of Salty's kits at the Philly show. Nice to meet Scott.
Now I'm in the process of getting my sh**t together... What sealer to start with, paint, hand tools etc.
Checked all the local "Home Stores" for small bolt cutters ($40) and round nose pliers, No go.
Stopped at the local Ace hardware on the way home, picked up a pair of 8" bolt cutters for $12.
Tried them out, nice close, clean cut. Easy on the hand. Would go with the Nipex if I were doing production work like Scott. Will be ordering the round nose. I actually enjoy the hunt... Spending money!
Thanks,
Tom C.