Salty's Forum

General Category => Plug / Lure Building Forum => Topic started by: anw0625 on December 09, 2010, 10:02:31 AM

Title: sanding ?
Post by: Out Fishing on December 09, 2010, 10:02:31 AM

I sealed some plugs the other day and now there is a slight grain, should I sand the grain down where the plug is smooth or will that remove the sealer?  Thanks

Title: Re: sanding ?
Post by: Out Fishing on December 09, 2010, 12:14:27 PM

If there is raised grain I'd lightly sand then dip it again.

Title: Re: sanding ?
Post by: Out Fishing on December 09, 2010, 09:38:19 PM

you can spray the plug with a mist before you seal it. it'll raise the grain once, shouldn't happen again.