« previous next »
Pages: [1]   Go Down

Author Topic: Screw-in eyes  (Read 3061 times)

0 Members and 1 Guest are viewing this topic.

Hobieblue

  • Guest
Screw-in eyes
« on: January 15, 2012, 05:08:50 PM »
I am going to start working on a couple 1.25 oz topwater gliders.  I have two quick questions: first, the kit comes with three screw-in eyes, one is shorter that the others...is that one the belly screw or the front screw?  Second: do I use epoxy or something to glue in the eye screws, or can they just get screwed in without glue?

Thanks.

HB
Logged

Offline Out Fishing

  • Admin
  • *****
  • Posts: 5648
Re: Screw-in eyes
« Reply #1 on: January 15, 2012, 05:53:37 PM »
Long ones front and rear and small goes in belly. Either use CA glue or 30 minute epoxy stuffed in the hole with a piece of wire.
Logged
Better to have a short life that is full of what you like doing than a long life spent in a miserable way....Alan Watts

Offline Out Fishing

  • ***
  • Posts: 207
Re: Screw-in eyes
« Reply #2 on: January 18, 2012, 08:28:23 PM »
Scott, no 30 min. Epoxy on your site?
Logged
Tom C

Offline Out Fishing

  • Admin
  • *****
  • Posts: 5648
Re: Screw-in eyes
« Reply #3 on: January 19, 2012, 05:20:40 AM »
No I can't get it through the distributor. Not satisfied with this.
Logged
Better to have a short life that is full of what you like doing than a long life spent in a miserable way....Alan Watts
Pages: [1]   Go Up
« previous next »