with a drill press.....and useing pine balaster square stock ... mark out your centers from corner to corner.......lathe out your plug...at the square ends of the plug find the centers of the squares ....draw lines from the marks across the plug top to bottm...... on these lines you will mark for the eyes, belly weight, belly hooks dont cut the square end off the plug yet......ill go to the drillpress using the cross marks on both ends of the plug ill drill threw to the belly and hook holes
than reverse the plug and drill threw to hit the hook hole.......now u can cut the square ends off....when u drill go slow and clean the bit as u go......if u drill useing a saltys drillbit....be warned they are extreamly sharp and they like to chew be careful good luck!
