I'm sure some of you have seen the Squid/Sperm plug. I want to add eyes to it. 1/2 molded ones.
What would be the best adhesive/glue? Thinking of Zap a Gap.

zap a gap works as does 5 or 30 minute epoxy

Which would you recomend? Fly cement???

I would use 30 minute epoxy. Would not recommend fly cement. Too thin.

well striper66.......if the plug is already finished and u drilled out for the eyes then like salty sez epoxy them in.

The plug is finished. My dilema.

nice sperm color

nice squid color if i say so my self

Best way to add 1/2 inch eyes without messing it up?

well use a sharp fostner bit in a drill press with a jig to hold the plug and go slow as not to ruine the paint........but remove the hooks for safety u dont want a hook in your arm or finger........or use 1/2 inch sticky eyes and e-tex the whole plug useing a spinner and  remove the hooks as well.........i think that was your question

I am not a plug builder. At all. I have this plug and would like to add the eyes to it. Is there away to just glue/epoxy the eyes on?

what he said.

As a sperm painter that thing looks hideous. Looks like it's been rolling around for 6 days in lilo's thing and it looks like it got run over by a mack truck

As a squid painter however I'd say you aced it.

use flat eyes with epoxy. Your going to ruin the paint. Next time you want to do all your drilling BEFORE you paint or finish.

I didn't paint it A friend in Maine did.

use flat eyes and be done with it

Cast out and yell THAR SHE BLOWS