|
Another Salty's kit
exclusive! 3 Oz
size, stainless steel thru-wired this is an exact copy of an original Danny
Pichney darter!
These
will swim with a wide darting action from side to side. These were fish slayers
a quarter century ago
and we've re-created them!
Many lure makers have copied this exact style body as it was so
effective.
All kits are
sanded out to 150 grit and require minimal sanding-see the special notes
below!
All components are included except for split rings and hooks, which we
recommend VMC 4/0 treble hooks for the belly
and tail of this lure.
We use only USA made components in our kits!
This
lure is an advanced kit. It requires gluing/epoxying the nose wire in, minor
sanding, and painting/finishing.
These kits are all turned on our dedicated kit cnc machine and drilled
with precision and duplication second to none!
Can be painted with ordinary spray bombs,
remember to seal first and then can be painted with Testors/acrylic paints and a small brush
from AC Moore,
let them dry thoroughly and coat with a few coats of
clear spray paint or brush with epoxy etc in thin coats for more
durability. See the pictorial page for more information.
Special notes on finishing this lure.
Do not use any more than 220 grit sandpaper on the nose of this lure.
If you sand the nose too much you will ruin the action of this lure and
it won't swim right.
I recommend that you very lightly "debur" the edges of the face of
the lure using light finger pressure in a direction from the outside to
the inside
so that you don't cause any splintering, and very lightly touch up the front of the lure
with 220 or 400 sandpaper so that you don't remove any stock.
Don't use a real thick coat of epoxy on these, keep them lightweight,
and always use a loop knot on the front, never tie direct.
Please read the pictorial and front swivel/nose loop setting on this
lure.
|
